• 10-标准按压三孔雾化手机.jpg

编号 :


High Quality Dental Handpieces Supplier Custom Surgery Single Spray High Speed Turbine 2 and 4 Holes Dental Handpiece



Head: Standard head Hole: 2/4 hole Bearing: Ceramic bearing Spray: Triple water spray Chuck type: Push-button

Product No.:GS3-P4-T2

Category: Fixed connection





  • Description
  • Parameter:
    ●Triple water spray,Triple air spray
    ●Push button
    ●Speed:320,000-420,000 min
    ●Working Air Pressure:0.2-0.25Mpa(2.0-2.5kgf/cm²)
    ●Bur spplicable:Φ1.59-Φ1.60mm
    ●Head Size:Φ10.7×H13mm

    1. Universal to the global dental chair;
    2.Autoclaved repeatedly;
    3.Open Cartridge,easy to replace bearings;
    4.Ceramic bearing longer service life,higher accuracy,lower noise,less vibration;
    5.Anti-slip patten,comfortable for hand feeling, easy to clean; 
    6.Cartridge with best ceramic bearing and dynamic testing(better sound/smooth/worklife);
    7.Good cooling system. Wear-resisting, efficient operation 3-way spray, soft push button.

    After Each Patient Is Used, The Following Maintenance Should Be Performed:
    1. First remove the diamond grinding bur and clean all dental deposits on the single spray high speed dental handpiece;
    2. Clean the spray hole and fumarole with a metal needle;
    3. Spray detergent into the shaft hole for 1-2 seconds (the diamond grinding pin has been inserted into the hole);
    4. There are two models at the bottom of the dental handpiece (with or without quick connectors), please spray the appropriate amount of lubricant at the bottom;
    5. Combine the dental handpiece and quick connector (make sure the water switch is off)
    6. Install the diamond grinding head and cover the dental handpiece with white gauze (make sure that the diamond grinding head does not come in contact with the white yarn to avoid tying);
    7. Depress the pedal for about 20 seconds to see if there is any stain on the white gauze. If the white yarn is smeared, lubricate it again and continue with the fourth routine maintenance. Know that the white yarn is not dyed;
    8. Finally, use high temperature autoclaving that does not exceed 135 degrees Celsius.

    • Dental handpiece
    • High speed handpiece
    • 4 Holes Dental Handpiece
    • 2 Holes Dental Handpiece

Product Inquiry